PowerGen Usage

[Joe Speroni]

I've just started my first PBDLL program using
PowerGen and DLGEDIT. I've found that Microsoft's
DLG generates a .H file with equates using C++
hexadecimal format 0x. These values Are used by
PowerGen but it outputs PB code that contains the
orginal format and it is necessary to edit them to
the &H syntax each time DLG/PowerGen is used.

Is there any way around this?

[Lance Edmonds]

Deselect OPTIONS | HEX MODE in DLGEDIT.EXE.



-------------
Lance
PowerBASIC Support
( mailto:[email protected][email protected]</A> )

[Joe Speroni]

Thanks. I went back and created a new dialog with the
hex option off, and the .h file was indeed created with
decimal values. I had previously created three dialogs
in the same file with the hex option set ON. I reset it off
and treid to regenerate them with decimal values. But it
did not work. Apparently once a .RES file is created with
hex set ON, it can not be reset. That did not occur to me.

I will reenter the dialogs and start over. Thanks for your
help!